Installation
How to Remove Old Blinds and Curtain Rods Without Damaging Walls

Taking the old blind down is ten minutes. Making the wall look like it was never there is the real job.
Before new blinds go up, the old ones have to come down. Old venetian, vertical and roller blinds, and heavy curtain rods, are often fixed with rusty screws and plugs that have been in the wall for years. Here is how to remove them cleanly and prepare the wall.
Tools you will need
- Screwdriver set (flat and Phillips)
- Pliers
- Putty knife or scraper
- Wall putty or filler
- Fine sandpaper
- Touch-up paint
- Ladder and a dust sheet
Removing a roller blind
- Roll the blind fully up.
- Push the non-chain end toward the chain side or press the bracket release, and lift that end out.
- Slide the chain end out of its bracket.
- Unscrew the brackets.
Removing a venetian blind
- Raise the blind fully and lock it.
- Remove any valance clipped to the headrail.
- Open the bracket covers (often hinged) and slide or lift the headrail out.
- Unscrew the brackets.
Removing vertical blinds
- Rotate vanes open, then unhook each vane from its carrier.
- Release the headrail from its clips — usually by pushing a tab and tilting.
- Unscrew the clips from the wall or ceiling.
Removing curtain rods
Lift off the rod, then unscrew each bracket. Heavy rods may have three or more brackets.
Dealing with stuck screws and old plugs
- For rusted screws, apply a drop of penetrating oil and wait a few minutes.
- If a screw spins without coming out, pull gently with pliers while turning.
- Old plastic or wooden plugs can be pulled with pliers, or pushed slightly in and filled over.
Filling the holes
- Clean dust out of each hole.
- Press wall putty or filler into the hole with a putty knife.
- Smooth flush with the wall, leave to dry.
- Sand lightly, wipe, and touch up with matching paint.
Can you reuse the old holes?
Sometimes. If old holes match the new bracket positions, new plugs can go in — but old holes are often enlarged or crumbly. It is usually better to drill fresh holes a little to the side and fill the old ones. Our guide on drilling concrete for brackets explains why.
Measure after removal, not before
Old blinds and rods can hide the true window edges, uneven plaster or obstructions. Take them down first, then measure for the new blinds. Use our measuring guide or book a free site measurement in Delhi NCR.
What to do with old blinds
- Aluminium slats can go to scrap metal dealers.
- Usable fabric blinds can go to a storeroom or be donated.
- Damaged PVC and fabric go with household waste — check local disposal guidance.
Professional help
When our team installs new blinds, they can remove the old ones as part of the visit — just mention it when booking. See what happens at an installation.
Choosing replacements
Many people replacing old venetians or verticals choose roller blinds (from ₹100 per sq ft) or zebra blinds (from ₹120 per sq ft) for easier cleaning and a modern look. Prices include GST.
Preparing the wall for new blinds
Once filler has dried and been painted, check that the wall surface is sound where new brackets will go. Loose plaster should be scraped back and repaired, otherwise new plugs will not hold firmly. If you are also repainting the room, fit the new blinds after painting is complete so fabric is not exposed to paint dust and fumes.
FAQs
Do I need to repaint after removing blinds?
Usually just a touch-up over filled holes. Older walls may show a colour difference where brackets sat.
How long does removal take?
Typically 10–20 minutes per window, plus drying time for filler.
Not sure of your sizes?
Read our measuring guide or try the AR self-measure tool to get exact numbers.
